43 Comentários

1. Please help
   I'm deep into debt with my 2003.
   It started fine, then quit.
   I need it diagnosed.
   Please!!!!

2. Hey man I was wondering my car had a crank no start so I watched this video an decided to look at the coil packs an spark plugs the one closest the the driver side had oil in the spark plug well so my question is how would I fix that? New cover an gasket?

3. Thank You for that information

4. 68 Nissan repair videos! I can dig it! I learned that coolant answer from Diagnose Dan! He had one that the sensor said engine was hot when actually it had not run that day. So computer was not sending enough fuel for it to start cold. As for the no compression, i go with Sylvia's guess. Chain tensioner failure. So Sylvia has to call & break the news to the customer? As long as valves didn't hit pistons, it won't be too expensive. Timing chain set and install. Can't wait and see!

5. Brotha, you're fortunate to have a woman by your side, learning, recording and supporting you 100%! Love the vids too! I'm just confused as to how the car goes from driving one day to no compression the next. Haven’t seen that one yet.

6. Great Video. Did you end up replacing the head gasket? My car wont start and I know I have a blown head gasket but I wasn't haven't issues starting it til recently. I previously replaced pretty much all my sensors and spark plugs and a faulty coil pack. I was thinking my fuel injectors might be clogged so I got some cleaner in the fuel but since it won't start properly it wont flow through it. Can a blown head cause the no start?

7. This guy is great. To the point, logical, knows his stuff, and I wanna have a beer with. Thanx for the knowledge.

8. Can you do a video for an 03 Nissan Altima 2.5s code p1564.

9. What happened with the timing?

10. 👏👏👏

11. Any idea 2003 nissan factory remote start acting up starts and dies right away. When I use key no issue starts and runs. I cleaned terminals and alil corrosion positive side but still same starts and dies. Any help

12. ECM GONE BAD ?

13. Where's the part 2 and fixing the problem. The video stopped when you can close to diagnosing the problem and can't find a part 2.

14. Just came across your page. My stepson bought 2002 Nissan Sentra gxe. Been running fine. Anyway he stops at store then wont start/crank. When i hooked my scanner up got codes etc. But it wont stay running unless OBDII is plugged in. I can use any OBDII dongle even if it's a blue toothunit not connected to reader. Any ideas??

15. So i got my valve cover repaired about two weeks ago and my spark plugs and ignition coils repaired as well all new. It started perfectly fine then about 10 mins later i came home and went to leave again and it’s cranking but won’t start. Could that mean i have a bad ignition coil or spark plug? Would that cause it to lot start? What are some reasons that could be wrong since i have all new spark plugs ignition coils and a new valve cover?

16. I came across your channel and to be honest I am learning a lot and I like family working together on the same field. Keep it up with the videos. Greetings from Finland !!!!!

17. My car is doing the same thing changed the spark plugs and coils also changed the position sensor car still wont start…help!!!

18. Nobody says potado everyone say potatoes.🎩

19. 2006 2.5 #3 cylinder not getting spark why?😣

20. My number 3 cylinder is not getting any spark coil been change.🤔

21. this exact same thing happened to me on my 2002nissan altima and how do i fix it?

22. hello, I have a 03 Nissan Altima 2.5 and I only get spark to 1 and 3 cylinder and 2 and 4 dont get any spark what could it be, just wondering

23. Did you find the cause of the no start condition??

24. Astral, obviously the problem's been fixed by now, but when I see that the compression gauge doesn't even quivering at all on any cylinder I would sure want to test the gauge on a known working cylinder on another car, or try another gauge before spending a lot more time/money looking looking into causes of absolutely NO compression on this puppy. You said customer reported this problem happened suddenly one morning after running the previous day. That doesn't sound like a compression problem. Please let me know what you found, if you don't mind. The suspense is killing me.

    Thanks, Ron

25. as you mentioned here after 12 min into the video, Got the code p0180 of coolant temperature on my 2001infiniti QX4, got your explanation about Injector pulse but how can we correct it was not explain. would you explain the corrections please. thank you in advance

26. Good, job she was very good keep working together. God bless.

27. Any updates?

28. I’m going to try the number three cylinder and check for comp just like you did in your video please help thanks

29. I got a customer 2003 Nissan Altima 2.5 liter I change the timing chain set new gears and oil pump chain the whole nine yards and I’m getting fire and fuel cranks but no start

30. Gotta love this channel this guy is so genuine and authentic. I just enjoy watching his videos in my free time even if I don’t have the car he’s working on. Great videos, great content and very knowledgeable! Thank you Astral Auto!

31. Nissan is junk. Honda or Toyota for the win

32. Love yoir attitude man. Also i HATE hearing lip smacking on the mic but you pull it off with ease lol

33. You can a rag to soak up some of that oil but I ain’t got time for that …splash…eeewww.ahh I’m gonna go get a rag….lol!!!!

34. Jumped TIME

35. You’re videos are good and easy to follow. Will use ya more in the future. Way COOL Thanks again. Jack

36. Bro do you kno all these cars at every junk yard lol.. The radio panel are bad asf there dammn near $200 n they brake easy… Nice video.. I'm still working on mines.. May the gud Lord best it to get right

37. My 2005 Altima does the same but it cranks after a certain amount of time

38. 29:23 you can see that there was compression in all cilynders by looking at the air blowing out of the spark plug tunes when he cranked it. Your compression gauge is bad.

39. Thanks for the helpful video! It really helped us out 🙂

40. You are smart bro. Thanx for the info. But the leaf technique 😂😂😂 then back in the engine

41. Have a 2002 altima 2.5s, having trouble starting. Got a code p0302 code , would this prevent it from starting?

42. Had this happen to me and you'll know when it's going bad because when you start the engine you'll hear a plastic rattle which will go away once the car starts. You'll hear this rattle months before it actually goes but make no mistake these cars are known for weak chain tensioner and chains. shop wants $1400. plus if any valves are messed up etc on an already 16 year old car = not happening. Car only has 68,000 original miles.

43. Anyone ever tell you sound and act like Kevin Hart?

Comentários estão fechados.