Why you should not go bigger than a 2.5inch spacer lift! (2.5in MotoFab Leveling kit 2016 Silverado)
Quick and easy leveling kit install. If you have the tools you can easily get this done. I used the Motofab leveling kit which will be linked in the description. The Motofab leveling kit offers an amazing ride on and off the road. I would highly recommend this one for something quick and affordable while keeping the comfortability and ride of the amazing 2016 Silverado.
Item:
Link do Vídeo
Tags:
2.5,
2.5in,
2.5inch,
2009 silverado,
2016 silverado,
2016 Silverado level kit install,
2017 2018,
3rd generation,
4x4,
5.3,
5.3L,
5th generation,
chevy,
diy,
leveling kit,
leveling kit 2016 silverado,
lift kit,
motofab,
motofab leveling kit,
silverado,
spacer lift,
z71
Follow my Instagram @theseventhadventure or @_sergi
I post there more often and can actually see the truck of how it sits now. The Instagram page is geared towards an offroad rig. Thanks!
Been running 3 and 2 in from Motofab for the past 150 thousand miles no issues with balljoints or axles and the ride is fine dont be a puss
What is the best way to get 3" lift on 2015 silverado 4×4 ?
Did you seriously call a strut spacer a wheel spacer and call a strut a coil over?
does it ride good still or very bumpy?
Did you loosen up all the upper control arm bolts or just the one that’s attached to the spindle, I tried installing this kit but the upper control arm would not come out
What was the measured thickness of spacer
.
What torque specs did you use?
where can I buy this kit?
Ball joints are still good after this time with the 2.5 in?
Looks like a truck should look very nice
So I start by taking out the middle then the outer 3 right?
what's wrong with the 3 inch level?
Nice. Would it be same set up for a 2011 Z71?
Your wheels in the bed you’re referring to are called tires. Wheels are the rims. Just FYI.
Clean truck my brother just got his 2019 6.5 I think is too much
I like helping people out,so On my 19' z71, (classic)Canadian version, so 18' body. I had a 2" and now a 3" motofab front 2¼ rear blocks. YOU WILL NEED UPPER CONTROL ARMS. And diff drop spacers. The angles are way to much. I do have a few videos on this. 1500km and the 3" caused my factory ball joints to work themselves out ⅛ out.
Have you noticed any problems since installed?
Great vid looking into the new Moto fab 2.5 level for my 2020 Silverado.
Great video bro very insightful